Mauser Red-9 Shoulder Stock
A little while back I picked up a Red-9 Mauser C96 (see below). I only got it because I liked the quirkiness of the setup for the wooden shoulder stock. So I immediately started looking for a wooden holster to match. Doing my research I discovered a few tell tales that would be useful for someone else looking for the same thing. In this case, the original stocks always had the tensioning screw end up at an angle 20 or 30 degrees off true. The Red-9 stocks had the squared off grain on the thumb release and this is always perpendicular to the edge of the lid. And finally these stocks were supplied without the metal loop at the hinge. If your stock has a loop then it is likely a bolo stock and post-war. It’s important to get the right holster as the wood that was removed from inside the cap was different to conform with the cocking lever setup. In the Red-9 series these were always the small ring style thumb grip.
Leave a Reply